CENTRALE PHENIX
PHENIX 2C-3
PHENIX 2C-6
Continuous recording of crack openings
GINGER CEBTP proposes the PHENIX 2C module for micro-movement
measurements. PHENIX 2C is a mini Datalogger linked
to 3 or 6 20 mm movement sensors which may be used in a variety
of applications where a classical data acquisition centre
is oversized.
It provides recordings of 3 or 6 movements and 1 temperature
continuously over a period of several months.
The PHENIX 2C is connected to a PC by a simple cable
or by a modem over an RTC or GSM network to collect the measurements
taken, remotely without any on-site intervention.
Its ease of use, its mini size, its performances and its low
cost make it a highly effective device for a wide variety
of applications and provide you with optimal ROI.
Applications
- Crack monitoring
- Structural movements
- Building subsidence etc. |
 |
Characteristics
- Autonomous 3 or 6 channel + 1 temp. channel recorder -20°C
- 65°C
- Movement resolution better than 10 µm
- 0.5°C temperature resolution
- 1 sec. to 24 hour adjustable acquisition period.
- Storage capacity: 3,000 measurements (3 movements + 1 temp.)
- 3.6 V lithium battery power supply, 4-month autonomy
- RS232 or modem over RTC network PC link
- Light (250 g), small (60´55´40 mm), highly robust
(aluminium alloy casing), IP65, very easy to use.
- Delivered with SUPER6 and SUPERGRAPHE
software for Windows for configuring the PHENIX
module and for collecting and processing data.
PHENIX 2C is an out-of-the-box product, delivered with the following accessories.
-
3 or 6 counter-thrust bracket plates
- 3 or 6 cables, length to be specified when ordering
- 1 logger-to-PC connection cable
- SUPER6 and SUPERGRAPHE software on CD
- 1 lithium battery |
 |
SUPER6
PHENIX 2C logger configuration software;
data transfer to PC for analysis using SUPERGRAPHE
SUPERGRAPHE
Analysis software for the data collected by PHENIX
2C; cursor-assisted analysis, on-screen graph design
and printability
Other crack measuring
device : The GINGER CEBTP GAUGE
The different
means for monitoring cracks and for measuring crack openings
You can obtain a complete set of documents about these new
equipments quickly by simply placing a request at :
M. Frédéric BOURDET
By Email
f.bourdet@gingergroupe.com
By Télécopie : +33 1 30 85 23 79
|
By courrier :
GINGER CEBTP
Service Pôle Systèmes
12 Avenue Gay Lussac
ZA La Clef St Pierre
78990 ELANCOURT
France
|
| |
|
| The texts in the present document only
have an information purpose, and neither their author
nor CEBTP are committed by them. |
The texts, schemes and photographs represented
in the present pages are an exclusive property of CEBTP
and they cannot be reproduced under any form without a
previous written authorization of CEBTP |
Copyright ©, 2009,
CEBTP All rights reserved
|
